查看“Kruse”的源代码

You can make fixing wall cladding and ceiling cladding easier and do work of greater good quality by following particular regular procedures. We appear at particular key procedures in the following sections. There is no try to contain all the finer points. Rather the aim is to give an overview and indicate some essential points that want attention.

The 1st step is to repair the bottom and top rated edge pieces, by screwing them to the wall. Next comes the process of sliding the cladding sheets into these pieces. After the sheet is in location, the horizontal joints are attached to the vertical ends of the sheets and screwed into the wall. Subsequent comes fixing internal and external angles at corners, and around doors and windows.

We appear at these fixing steps in a little far more detail beneath.

Top rated and Bottom Edges

All 4 edges of all sheets must be secured to the wall. In most circumstances, J edges, H joints and internal/external angles can do the job. Where necessary, Maxbash Skirting can be employed at the bottom as an alternative of a J edge. For quite uneven walls, two-piece joints can be utilized amongst sheets.

Exactly where only wall cladding is becoming installed, the best edges can also be secured making use of a J edge. If ceiling cladding is also getting installed, you might favor trapping the best of the wall cladding sheets with the ceiling. Alternatively, a 2-piece internal corner is employed as a coving.

Very good quality silicone beading is utilized between the wall and J edge/Maxbash skirting to seal them permanently to the wall and floor.

Fixing Cladding Sheets

Flex a cladding sheet into the top rated and bottom J edges and fit a one particular-piece H joint to the vertical edge of the sheet, leaving required space for any expansion in the sheet. Secure the joint to the wall.

Now flex in a second sheet into the J edges and H joint and repair a joint on the other vertical edge of the sheet. Continue the procedure till the walls are completely covered.

Silicone sealant is utilized between sheets and J edges/H joints to seal the sheets.

Corners

Corners are usually fixed making use of internal and external angles. If the corners are not square, a universal angle is employed. This type of angle has a flexible center that can be bent to a desired degree.

Common
 [http://americanfibercement.com/ rain screen]
The above outline is intended only to give a common notion. There could be finer points that need to have to be mastered to solve certain difficulties in actual working. For these, you can refer to the instruction manual that comes with the sheets. Do take the difficulty to go by way of the manual carefully. It could imply the distinction among good quality operate and less-than-excellent function.

Conclusion

This write-up outlined how cladding sheets are fixed to walls. The standard procedure is to screw the bottom and best J edges first, flex a sheet into them, fix an H joint to the vertical edge of the sheet, add the next sheet into this joint as properly the its personal J edges, and so on.

Corners are fixed utilizing internal and external angles.

Very good quality silicone sealant is utilised to ensure waterproof sealing of the entire surface.